All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The spanning tree principles that the document presents are applicable to almost all devices that support STP. ![]() The information in this document is based on these software and hardware versions:Ī console cable that is suitable for the Supervisor Engine in the switch There are no specific requirements for this document. I could share the modifications I made to get it to work, but it wouldn’t be a readily mergeable PR as it breaks a few things in epw.py.This document describes how to use Spanning Tree Protocol (STP) to ensure that you do not create loops when you have redundant paths in your network. ![]() From what I gathered, the case of an analysis period shorter than a full year is not supported. But again, perhaps this is insignificant. I guess the effect of the change has been deemed minimal and this is better than having an hour shift all along.Īnyway, this seems even more wrong if the year is incomplete, as the last value may match the next to last even less. This must have been discussed already, and I don’t mean to reopen the discussion. For instance, midnight air temperature on two successive new year’s eve may be very different so this move may send a -5☌ just after a -5☌, introducing a 10☌ step. I find it strange to do even on full years because it may introduce a step while the data may be meant to be more or less continuous. # if the first value is at 1AM, move first item to end position
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |